HEIDENHAIN TNC 320 - Fundamentals; Overview

Fixed Cycles: Pocket Milling / Stud Milling / Slot Milling
5.1 Fundamentals
5
130
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
5.1 Fundamentals
Overview
The TNC offers the following cycles for machining pockets, studs
and slots:
Soft key Cycle Page
251 RECTANGULAR POCKET
Roughing/finishing cycle
with selection of machining
operation and helical plunging
131
252 CIRCULAR POCKET
Roughing/finishing cycle
with selection of machining
operation and helical plunging
136
253 SLOT MILLING
Roughing/finishing cycle
with selection of machining
operation and reciprocal
plunging
141
254 CIRCULAR SLOT
Roughing/finishing cycle
with selection of machining
operation and reciprocal
plunging
146
256 RECTANGULAR STUD
Roughing/finishing cycle with
stepover, if multiple passes
are required
151
257 CIRCULAR STUD
Roughing/finishing cycle with
stepover, if multiple passes
are required
155
233 FACE MILLING
Machining the face with up to
3 limits
164