HEIDENHAIN TNC 320 - Cycle Parameters

FLOOR FINISHING (Cycle 23, DIN/ISO: G123) 7.7
7
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
201
Cycle parameters
Q11 Feed rate for plunging?: Traversing speed of
the tool in mm/min during plunging. Input range 0 to
99999.9999, alternatively FAUTO, FU, FZ
Q12 Feed rate for roughing?: Traversing speed
of the tool in the working plane. Input range 0 to
99999.9999, alternatively FAUTO, FU, FZ
Q208 Feed rate for retraction?: Traversing speed
of the tool in mm/min when retracting after the
machining operation. If you enter Q208 = 0, the
TNC retracts the tool at the feed rate Q12. Input
range 0 to 99999.9999, alternatively FMAX,FAUTO
NC blocks
60 CYCL DEF 23 FLOOR FINISHING
Q11=100 ;FEED RATE FOR
PLNGNG
Q12=350 ;FEED RATE F.
ROUGHNG
Q208=9999;RETRACTION FEED
RATE