HEIDENHAIN TNC 320 - Cycle Parameters; Retracting after a Program Interruption

RIGID TAPPING without a floating tap holder (Cycle 207,
DIN/ISO: G207)
4.3
4
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
99
Cycle parameters
Q200 Set-up clearance? (incremental): Distance
between tool tip and workpiece surface Input range
0 to 99999.9999
Q201 Depth of thread? (incremental): Distance
between workpiece surface and root of thread.
Input range -99999.9999 to 99999.9999
Q239 Pitch?: Pitch of the thread. The algebraic sign
differentiates between right-hand and left-hand
threads:
+ = right-hand thread
–= left-hand thread
Input range -99.9999 to 99.9999
Q203 Workpiece surface coordinate? (absolute):
Coordinate of the workpiece surface. Input range
-99999.9999 to 99999.9999
Q204 2nd set-up clearance? (incremental):
Coordinate in the spindle axis at which no collision
between tool and workpiece (fixtures) can occur.
Input range 0 to 99999.9999
NC blocks
26 CYCL DEF 207 RIGID TAPPING NEW
Q200=2 ;SET-UP CLEARANCE
Q201=-20 ;DEPTH OF THREAD
Q239=+1 ;THREAD PITCH
Q203=+25 ;SURFACE COORDINATE
Q204=50 ;2ND SET-UP
CLEARANCE
Retracting after a program interruption
Retracting in the Manual Operation mode
You can interrupt the thread cutting process by pressing the NC
Stop key. A soft key for retracting the tool from the thread is
displayed in the soft-key row below the screen. When you press
this soft key and the NC Start key, the tool retracts from the
hole and returns to the starting point of machining. The spindle
is stopped automatically and the TNC displays a message.
Retracting in the Program Run, Single Block or Full Sequence
mode
You can interrupt the thread cutting process by pressing the
NC Stop key. The TNC displays the MANUAL TRAVERSE soft
key. After you pressed the MANUAL TRAVERSE soft key, you
can retract the tool from the active spindle axis. To resume
machining after the interruption, press the RESTORE POSITION
soft key and NC Start. The TNC moves the tool back to the
position it had assumed before the NC Stop key was pressed.
When retracting the tool you can move it in the
positive and negative tool axis directions. Please
keep this in mind during retraction—danger of
collision!