HEIDENHAIN TNC 370 D - Page 72

July 02 Machine Parameters TNC 370 D 4–69
Machine
parameter
Function and input Change via Reaction
MP6510 Max. permissible measuring error for tool
measurement with rotating tool
Input: 0.002 to 0.999 [mm]
CN
PLC
MP6520 Probing feed rate for tool measurement with
non-rotating tool
Input: 10 to 3 000 [mm/min]
CN
PLC
RUN
MP6530 Distance from tool lower edge to probe
contract upper edge for tool radius
measurement
Input: 0.001 to 30.000.000 [mm]
CN
PLC
MP6531 Diameter or edge length of the TT 120
probe contact
Input: 0.001 to 99 999.9999 [mm]
PLC
MP6540.0 Safety zone around the probe contact
TT 120 for pre-positioning in linear
measurement
Input: 0.001 to 30 000.000 [mm]
CN
PLC
MP6540.1 Safety zone around the probe contact
TT 120 for pre-positioning in radius
measurement
Input: 0.001 to 30 000.000 [mm]
CN
PLC
MP6550 Rapid traverse in probing cycle for TT 120
Input: 10 to 20 000 [mm/min]
CN
PLC
RUN
MP6560 M function for spindle orientation with
single-tooth calibration
Input: –1 to 88
–1 = spindle orientation directly via NC
0 = function inactive
1 to 88 = Number of the M function for
spindle orientation via PLC
CN
PLC
RUN
MP6570 Max. permissible surface cutting speed at
the tool edge
Input: 1.000 to 120.000 [m/min]
CN
PLC
MP6580
MP6580.0-2
Coordinates of the TT 120 probe center
referenced to the machine datum
Input: –30 000.000 to
+30 000.000 [mm]
Axes 1 to 3
CN
PLC