HEIDENHAIN TNC 370 - 11.6 Selecting Position Display Types

11 MOD Functions
4
11.6 Selecting Position Display Types
The positions indicated in Fig. 11.2 are:
l Starting position @
l Target position of the tool @
l Workpiece datum @J
l Scale datum @
L
Fig. 11.2: Characteristic positions on the workpiece and scale
As standard, the TNC shows only actual positions. With the additional
position display you can also display the following types of position values:
l Nominal position (the value presently
commanded by the TNC) @ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . NOML.
. Actual position (the position at which the
tool is presently located) @ . . . ..__.._..........................................,.., ACTL.
l Servo lag (difference between the nominal
and actual positions) @
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LAG
l Reference position (actual position as
referenced to the scale datum) @ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . REF
l Distance remaining to the programmed position
(difference between actual and target positions) @
. ..__ DIST.
Select the desired information with the ENT key. It is then displayed
directly in the status field.
11-6
TNC 370