HEIDENHAIN TNC 370 - Page 315

12 Tables, Overviews and Dialogs
12.1 General User Parameters
Override behavior, &ctronie ha-~1
Override
MP7620 Feed rate override not effective when rapid traverse key pressed: +O
Feed rate override effective when rapid traverse key pressed: +l
Feed rate override not effective when rapid traverse key and machine axis direction button pressed: +O
Feed rate override effective when rapid traverse key and machine axis direction button pressed: +4
1 % increments for feed rate override: +O
0.01 % increments for feed rate override: +8
Handwheel type
MP7640 Machine without handwheel: 0
HR 330 with additional keys -the handwheel keys for traverse direction and rapid traverse are
evaluated by the NC: 7
HR 130 without additional keys: 2
HR 330 with additional keys -the handwheel keys for traverse direction and rapid traverse are
evaluated by the PLC: 3
HR 332 with twelve additional keys: 4
Multi-axis handwheel with additional keys: 5
HR410: 6
L
TNC 370
12-9