6 – 254 HEIDENHAIN Technical Manual TNC 426, TNC 430
Module 9083 Showing a moving-bar diagram in the small PLC window
The moving-bar diagram is shown in the specified line with the specified
length and colors.
The diagram can also be limited to the left half of each line. In this case the
ASCII text is limited to max. 19 characters in the right half.
The diagram comprises a rectangular frame in the maximum length and height
of an ASCII character. A scale graduation is shown at the top after every ten
units. The bar starts from the left-hand edge of the grid. The unused part of
the grid is filled in with the background color.
If you define the maximum length > 150, the length is limited to 150. If the
current length is > 150, the length is limited to the maximum length.
Color zero uses the background color of the currently selected graphic.
(MP736x.1). Color two is the background color of the PLC window. It can be
used, for example, for margin or scale graduation if they are not to be shown.
The color must be selected with MP735x according to the table ((See “Color
Setting” on page 6 – 225)).
Call:
PS K/B/W/D <Line number>
0 or 1
PS K/B/W/D <Color for bar>
0 to 15
PS K/B/W/D <Color for margin and scale graduation>
0 to 15
PS K/B/W/D <Current length of the bar>
0 to 150
PS K/B/W/D <Maximum length of the bar>
0 to 150
CM 9083
Error recognition:
19
0
150
0
Line 0
Line 1
Column
Marker Value Meaning
M4203 0 No error
1 Call was not in a spawn or submit job or line less than
0 or greater than 1
To Next Page
Loading...
