HEIDENHAIN TNC 426 PB - Page 686

6 – 356 HEIDENHAIN Technical Manual TNC 426, TNC 430
Example "Calibration of measuring touch probe";
„___________________“;
%02.2d-%02.2d-%4d:%02.2d:%02.2d "Time",DAY,MONTH,YEAR4,HOUR,MIN,SEC;
Probe axis:"%s",TA;
Probe radius 1: "%4.3lf" TM.RAD;
Probe radius 2: "%4.3lf",TM.RAD2;
Ring diameter: "%4.3lf",TM.RINGDIA;
Factors: X = "%4.4lf",TM.CORSTA[0];
Y = "%4.4lf",TM.CORSTA[1];
Z = "%4.4lf",TM.CORSTA[2];
Force ratio: FX/FZ = "%4.4lf",TM.CORDYN[0];
FY/FZ = "%4.4lf", TM.CORDYN[1]
NA String Minor-axis character
TA String Probe axis character
Calculated straight lines from straight-line probing
Name Format type Description
GE_HA[2] Double Straight-line axis section of reference axis
GE_NA[2] Double Straight-line axis section of minor axis
GE_WI[2] Double Straight-line angle
Calculated radii from circle probing
Name Format type Description
RAD[8] Double 8 radii
Calculated center points from circle probing
Name Format type Description
MP_HA[8] Double Reference axis of center points
MP_NA[8] Double Minor axis of center points
Accumulated touch points from probes
Name Format
type
Description
AP_HA[32] Double Touch points in reference axis
AP_NA[32] Double Touch points in minor axis
AP_TA[32] Double Touch points in probe axis
Datum at corner, circle, 4 holes, 3 holes on a circle
Name Format type Description