HEIDENHAIN TNC 430 PA/M - Tool Touch Probe; Further Components

December 2001 Overview of Components 2 – 21
Documentation Items supplied with the control include:
n 1 User’s Manual for conversational programming
n 1 User’s Manual for ISO programming
n 1 Pilot (brief user’s programming guide)
The HEIDENHAIN inverters and motors for the TNC 426 M and the
TNC 430 M are described in the Technical Manual “Inverter Systems and
Motors.”
The components required for operating the TNC 426 and TNC 430 with non-
HEIDENHAIN inverter systems are described in the “Technical Information for
Operation of SIMODRIVE and POWER DRIVE inverter systems.”
You will receive a set of supplementary pages every time changes are made
to this manual.
TT 130 Tool Touch Probe
Touch-trigger probe for measuring tools.
Id. Nr. 296 537-xx
Id. Nr. 335 332-xx
TT 130
Adapter cable for
connection to the LE
Further components Id. Nr.
Options for TNC 426 CB/PB, TNC 430 CA/PA
Additional position input for a 6th or 9th axis
(350 kHz)
311 537-51
Only TNC 430 PA:
Position input for 3 additional axes with nominal
speed command interface (350 kHz)
294 130-51
Ethernet interface 293 890-xx
Digitizing with triggering 3-D touch probe 286 405-01
Digitizing with a measuring 3-D touch probe
(SP 2/1)
311 647-51
Options for TNC 426 M, TNC 430 M
Ethernet interface 293 890-xx
Digitizing with triggering 3-D touch probe 286 405-01
Digitizing with a measuring 3-D touch probe
(SP 2/1)
325 818-51
Adapters for encoder signals
TTL (HEIDENHAIN layout)/1 V
PP
317 505-01
TTL (SIEMENS layout)/1 V
PP
317 505-02
11 µA
PP
to LE 426 M, LE 430 M
(as of xxx xxx-3x)
317 505-05
11 µA
PP
/1 V
PP
313 119-01