6 – 382 HEIDENHAIN Technical Manual TNC 426, TNC 430
Module 9036 Writing status information
Prerequisite: MP7641 = 1
The information to be overwritten is designated with a transferred number.
Handwheel interpolation factors are limited to a smallest possible value,
depending on the rapid traverse rate of the respective axis.
CAUTION! No error message!
Call:
PS B/W/D/K <Number of the status information>
PS B/W/D/K <Value to be written>
CM 9036
PL B/W/D <Error code>
0: Status written
1: Incorrect status code
2: Transferred value out of range
3: Input disabled
Error recognition:
Number Function Value
0 Handwheel interpolation key X 0 to 10
1 Handwheel interpolation key Y 0 to 10
2 Handwheel interpolation key Z 0 to 10
3 Handwheel interpolation key IV (MP410.3) 0 to 10
4 Handwheel interpolation key V (MP410.4) 0 to 10
5 Handwheel interpolation of all axes 0 to 10
6 Select the handwheel axis (not for HRA 110) 0 to 8
Axes 1 to 9
10 See ”Incremental Jog Positioning”
11 Handwheel interpolation of axis 1 0 to 10
12 Handwheel interpolation of axis 2 0 to 10
13 Handwheel interpolation of axis 3 0 to 10
14 Handwheel interpolation of axis 4 0 to 10
15 Handwheel interpolation of axis 5 0 to 10
16 Handwheel interpolation of axis 6 0 to 10
17 Handwheel interpolation of axis 7 0 to 10
18 Handwheel interpolation of axis 8 0 to 10
19 Handwheel interpolation of axis 9 0 to 10
Marker Value Meaning
M4203 0 Status information was written
1 Error code in W1022
W1022 1 Transferred value out of range
2 Incorrect number of the status information
6 Input disabled
To Next Page
Loading...
