HEIDENHAIN TNC 430 PA - Principle and Overview

4 – 14 HEIDENHAIN Technical Manual TNC 426, TNC 430
MP111 Position encoder input for the spindle(s)
Input: 0: No position encoder input
1 to 6: Position encoder inputs X1 to X6
35 to 38: Position encoder inputs X35 to X38
280 474-03 6 – 18,
6 – 181
MP111.0 Position encoder input for the first spindle
MP111.1 Position encoder input for the second spindle
MP112.0-8 Assignment of speed encoder inputs to the axes
Input: 0: No speed encoder input
15 to 20: Speed encoder inputs
X15 to X20
62 to 64: Speed encoder inputs
X62 to X64
280 474-03
RESET
6 – 16
MP113 Speed encoder for the spindle(s)
Input: 0: No speed encoder input
15 to 20: Speed encoder inputs
X15 to X20
60: Speed encoder input X60
(only LE with integral spindle DSP)
62 to 64: Speed encoder inputs
X62 to X64
280 474-03
RESET
6 – 18,
6 – 183
MP113.0 Speed encoder for the first spindle
MP113.1 Speed encoder for the second spindle
MP115.0 Position encoder input 1 V
PP
or 11 µA
PP
Format: %xxxxxxxxxx
Input: Bit 0 to bit 5: Position encoder inputs
X1 to X6
Bit 6 to bit 9: Position encoder inputs
X35 to X38
0: 1 V
PP
1: 11 µA
PP
280 474-01
RESET
6 – 9
MP115.1 Reserved
Format: %xxxxxxxxxx
Input: Enter %0000000000
MP115.2 Input frequency of the position encoder inputs
Format: %xxxxxxxxxx
Input: Bit 0 to bit 5: Position encoder inputs
X1 to X6
Bit 6 to bit 9: Position encoder inputs
X35 to X38
With 1 V
PP
:
0: 50 kHz
1: 350 kHz
With 11 µA
PP
:
0: 50 kHz
1: 150 kHz
MP Function and input Software
version and
behavior
Page