HEIDENHAIN TNC 430 PA - Page 258

4 – 20 HEIDENHAIN Technical Manual TNC 426, TNC 430
MP1090 Maximum permissible jerk on the tool path
Input: 0.1 to 1000.0 [m/s or 1000°/s]
PLC
RUN
6 – 118
MP1090.0 With machining feed rate
MP1090.1 Beginning with feed rate from MP1092
MP1092 Feed rate threshold from which MP1090.1 becomes
effective
Input: 10 to 300 000 [mm/min]
PLC
RUN
6 – 118
MP1094 HSC filter
Input: 0: HSC filter inactive
0.1 to 166.0: Cutoff frequency for HSC filter
280 474-07 6 – 118
MP1095 Nominal position value filter
Input: 0: Single filter
1: Double filter
PLC
RUN
6 – 118
MP1095.0 In the Program Run, Full Sequence; Program Run, Single
Block; and Positioning With Manual Data Input operating
modes
MP1095.1 In the Manual, Handwheel, Jog Increment and Pass Over
Reference Point operating modes
MP1096 Tolerance for contour transitions
Input: 0: No nominal position value filter
0.001 to 3 000 [mm]
PLC
RUN
6 – 118,
6 – 153
MP1097.0-8 Max. permissible axis-specific jerk (single/HSC filter)
Input: 0.1 to 1000.0 [m/s or 1000°/s]
PLC
RUN
6 – 118
MP1098.0-8 Max. permissible axis-specific jerk (double/HSC filter)
Input: 0.1 to 1000.0 [m/s or 1000°/s]
PLC
RUN
6 – 118
MP1099 Minimum filter order
Input: 0 to 20
PLC
RUN
6 – 118
MP1099.0 Minimum filter configuration for single filter (MP1095 = 0)
MP1099.1 Minimum filter configuration for double filter (MP1095 = 1)
MP1110.0-8 Standstill monitoring for axes 1 to 9
Input: 0.0010 to 30.0000 [mm]
PLC 6 – 162
MP1140.0-8 Threshold from which movement monitoring is effective for
axes 1 to 9
Input: Analog axes: 0.030 to 10.000 [V]
Digital axes: 0.030 to 10.000 [1000 min]
Recommended: 0.030 [1000 min]
PLC
RUN
6 – 161
MP Function and input Software
version and
behavior
Page