December 2001 List of Machine Parameters 4 – 33
MP3240.1 Analog spindle: Minimum nominal value voltage
Input: 0 to 9.999 [V]
Digital spindle: Minimum motor speed
Input: 0 to 9.999 [1000 rpm]
PLC
RUN
6 – 187,
6 – 188
MP3240.2 Analog spindle: Spindle jog voltage for gear shifting
(M4009/M4010)
Input: 0 to 9.999 [V]
Digital spindle: Motor speed for gear shifting (M4009/
M4010)
Input: 0 to 9.999 [1000 rpm]
MP3310 Limitation for spindle speed override
Input: 0 to 150 [%]
PLC
RUN
6 – 191
MP3310.0 Upper limit
MP3310.1 Lower limit
MP3411.0-7 Ramp gradient of the spindle with M03 and M04 for gear
ranges 1 to 8
Input: Analog axes: 0 to 1.999 [V/ms]
Digital axes: 0 to 1.999 [(1000 rpm)/ms]
PLC
RUN
6 – 185
MP3412 Multiplication factor for MP3411.x
Input: 0.000 to 1.999
PLC
RUN
6 – 186,
6 – 202,
6 – 207,
6 – 211
MP3412.0 With M05
MP3412.1 With oriented spindle stop
MP3412.2 With tapping with floating tap holder
MP3412.3 With rigid tapping
MP3415 Overshoot behavior of the spindle with M03, M04 and M05
Input: 0 to 1000 [ms]
PLC
RUN
6 – 185,
6 – 202,
6 – 207,
6 – 211
MP3415.0 With M03, M04 and M05
MP3415.1 For oriented spindle stop
MP3415.2 With tapping
MP3415.3 With rigid tapping
MP3420 Spindle positioning window
Input: 0 to 360.0000 [°]
PLC
RUN
6 – 202
MP3430 Deviation of the reference mark from the desired position
(spindle preset)
Input: 0 to 360 [°]
PLC
RUN
6 – 202
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
