4 – 62 HEIDENHAIN Technical Manual TNC 426, TNC 430
MP7500 Tilting working plane
Format: %xxxxxxxxx
Input: Bit 0 – “Tilted working plane”
0: Off
1: On
Bit 1 –
0: Angles correspond to the position of the
tilting axes of the head/table
1: Angles correspond to the spatial angle
(the TNC calculates the position of the
tilting axes of the head/table)
Bit 2 –
0: With Cycle 19 the tilting axes are
not positioned
1: With Cycle 19 the tilting axes are positioned
Bit 3 –
0: The active tilting-axis position,
with respect to the machine datum,
is included.
1: The first axis assumes a 0° position
Bit 4 –
0: The mechanical offset when changing the
spindle head when calling M128, M114 or
“tilted working plane” is compensated for
1: Mechanical offset during PLC
datum shift is compensated for
PLC 6 – 81
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
