6 – 16 HEIDENHAIN Technical Manual TNC 426, TNC 430
MP110.0-8 Assignment of position encoder inputs to the axes
Input: 0: No position encoder input
1 to 6: Position encoder inputs X1 to X6
35 to 38: Position encoder inputs X35 to X38
MP112.0-8 Assignment of speed encoder inputs to the axes
Input: 0: No speed encoder input
15 to 20: Speed encoder inputs X15 to X20
62 to 64: Speed encoder inputs X62 to X64
MP120.0-8 Assignment of speed encoder outputs to the axes
As of software version:280 474-01
Input: 0: No servo-controlled axis
1 to 6: Analog outputs 1 to 6 at terminal X8
7 to 13: Analog outputs 7 to 13 at terminal X9
51 to 59: Digital outputs X51 to X59
MP120.0-8 Assignment of speed encoder outputs to the axes
As of software version:280 470-01
Input: 0: No servo-controlled axis
A1 to A6: Analog outputs 1 to 6 at terminal X8
A7 to A13: Analog outputs 7 to 13 at terminal X9
D1 to D6: Digital axes 1 to 6
Note
When assigning the speed command signal outputs of the
LE 426 M and LE 430 M, please note arrangement of power modules.
Note
NC software 280 470-xx:
Only the values from 0 to A13 are permissible. Digital axes are entered in
MP2000.
To Next Page
Loading...
