December 2001 Tilting Axes 6 – 57
Step 7
n Position C = 180
n Probe surface Y2
n ∆Y2 = determined value
n Z1 = ∆Y2 – probe length + ball radius
n If there is a difference between MP7530.0 and Z1, then MP7530.0 = 0.5 * (MP7530.0 + Z)
Step 8
n Position C = 0
n Position B = –90
n Probe surface Z
n ∆Z = determined value
n Position B = +90
n Probe surface Z
n Z = {[–0.5 * (∆Z + determined value) – probe length + ball radius] – Z1} / cos 45°
(Z1 see step 7)
n If there is a difference between MP7530.3 and Z, then MP7530.3 = 0.5 * (MP7530.3 + Z)
To Next Page
Loading...
