HEIDENHAIN TNC 430 PA - Page 548

6 – 218 HEIDENHAIN Technical Manual TNC 426, TNC 430
Switching from spindle to axis:
7
77
7 Stop the spindle.
7
77
7 Switch to the gear range required for axis operation.
7
77
7 Switch the spindle motor to the axis.
7
77
7 With Module 9156, switch the axis from the open-loop to the servo-
controlled state.
7
77
7 With Module 9161 bit 15, release the current and speed controllers.
7
77
7 Release the axis clamping.
7
77
7 Close the position control loop of the axis by setting the corresponding bits
in W1040.
7
77
7 Begin axis operation.
Switching from axis to spindle:
7
77
7 Stop the axis.
7
77
7 Clamp the axis.
7
77
7 Open the position control loop of the axis by resetting the corresponding
bits in W1040.
7
77
7 With Module 9155, switch the feedback control for the axis off.
7
77
7 Switch the spindle motor from the axis back to the spindle.
7
77
7 With Module 9161 bit 15, release the current and speed controllers.
7
77
7 Shift back to the original gear range.
7
77
7 Begin spindle operation.
Note
Up to NC software 280 476-02, the bit for the spindle must always be
transferred to Modules 9161 and 9162. As of 280 476-03, the bit for the axis
or for the spindle can be given.