December 2001 Display and Operation 6 – 243
5 Selected file in ”Programming and
editing” and ”Test run” modes
0: No file
1: .H (conversational NC PGM)
2: .I (ISO NC PGM)
3: .T (tool table)
4: .D (datum table)
5: .P (pallet table)
6: .A (ASCII file)
7: .TCH (pocket table)
6 Selected file in ”Program run, full
sequence” and ”Program run, single
block”
0: No file
1: .H (conversational NC PGM)
2: .I (ISO NC PGM)
7 Selected axis for actual position
capture in PROGRAMMING AND
EDITING
0 to 8: Axes 1 to 9
8 Selected axis for actual position
capture in POSITIONING WITH
MANUAL DATA INPUT
0 to 8: Axes 1 to 9
9 Handwheel axis –1: None or more than one
Axes 1 to 9
10 Handwheel axis, bit encoded Axis 1 to 9
Handwheel interpolation factor
11
12
13
14
15
X key
Y key
Z key
IV key
V key
0 to 10
16 Input format of the $MDI file 0: .H (conversational NC PGM)
1: .I file (ISO NC PGM)
17 Display format 0: MM
1: INCHES
18 Working plane Bit 0=1: Tilting is active
Bit 1=1: Tilting is selected for manual operation
Bit 2=1: Tilting is selected for program run
19 Active line in the .CMA file >=0: Line number
–1: No .CMA file
20 HR 410 speed 0: Slow
1: Medium
2: Fast
21 Control model 0: TNC 310
1: TNC 370
2: TNC 410
3: TNC 426 CA/PA
4: TNC 426 CB/PB/M or TNC 430 CA/PA/M
22 Status of M128 0: M128 not active
1: M128 active
Transferred number Return code
To Next Page
Loading...
