6 – 244 HEIDENHAIN Technical Manual TNC 426, TNC 430
Call:
PS B/W/D/K <Number of the desired status information>
CM 9035
PL B/W/D <Status information>
Error recognition:
23 Handwheel superimposition with
M118
Handwheel interpolation factor
31
32
33
34
35
36
37
38
39
Axis 1
Axis 2
Axis 3
Axis 4
Axis 5
Axis 6
Axis 7
Axis 8
Axis 9
0 to 10
1000 Table editor (only in a spawn job or
submit job)
>= 0: Active line in the table editor
–1: Table editor not active
1001 Pallet table (only in a spawn job or
submit job)
>= 0: Active line in the pallet table
–1: Pallet table not active
1002 Status of pallet processing –1: Main program is not a pallet table.
0: Processing was not started.
1: NC program is selected but not started.
2: NC program was started.
3: Pallet-change macro was started.
4: Macro from the PALEPILOG entry in the
NCMAKRO.SYS was started.
5: Pallet-change macro was started by the PLC
(Module 9280).
Transferred number Return code
Marker Value Meaning
M4203 0 No error
1 Error code in W1022
W1022 1 Status information invalid
20 Call was not in a submit or spawn job
To Next Page
Loading...
