December 2001 Software Releases 2 – 59
NC software
280 474-15 (export
version 280 475-15)
Release: 10/99
Improvements:
n MP2221: Monitoring of rotational direction for spindle with integral DSP
n Input range of the STR column in the motor tables expanded
n When operating two spindles, the speed encoder may be disconnected and
reconnected
n Direction monitoring of digitally controlled spindles
n M4179: Control is shut down
n M4220: Error from PET table/F stop active
n M4221: Error from PET table/NC stop active
n M4222: Error from PET table/EM. STOP active
n Before the PLC program is converted, the PLC outputs are reset.
n Module 9002, 9003, 9005, 9008, 9009: Error code 24 (Module was called in
the submit job or spawn job) added
n Module 9130: New error codes 1 (Invalid analog output) and 2 (Disabled
analog output) added
n Module 9189: The drive ready signal is removed
n ISO: The Q key of the numerical keypad or the ASCII keyboard may be used
n When the control is shut down, the hard disk is put into sleep mode.
n Improved search function
n Cycles 400 to 403: An error message appears if a measurement in a tilted
plane is to be carried out
n Cycle 204: A value with digits after the decimal point may be entered in
Q255
NC software
280 474-16 (export
version 280 475-16)
Release: 03/00
Improvements:
n MP420, MP430: Changes no longer lead to a control reset
n MP2600: Input range changed
n MP6510: Second measuring error added
n MP7640, MP7641, MP7645 are no longer shown through code number 123
n A German and an English machine parameter description, as well as the
configuration files for CycleDesign, are saved in PLC:\JH.
n M141: Suppress touch probe monitoring
To Next Page
Loading...
