December 2001 Commissioning 6 – 491
Set to operation with following error.
7
77
7 Enter the following test program:
LBL2
L X<maximum traverse> R0 FMAX
L X0 R0 FMAX
CALL LBL1 REP 100/100
7
77
7 Start the test program.
7
77
7 Display the actual feed rate (actl. speed) with the internal oscilloscope:
• If no oscillations are recognizable, no kink point is required.
• If oscillations are visible, you must reduce MP1820.x until the oscillations
have disappeared.
MP1820 optimum
MP1820 too small
To Next Page
Loading...
