HEIDENHAIN TNC 430 PA

To Next Page

To Previous Page

7 – 2 HEIDENHAIN Technical Manual TNC 426, TNC 430

7.11 Cooperative Multitasking.......................................................... 7 – 163

7.11.2 Control of Events ................................................................. 7 – 164

7.12 Constants Field (KF)................................................................... 7 – 169

7.13 Program Structures ................................................................... 7 – 170

7.13.1 IF ... ELSE ... ENDI structure ............................................... 7 – 171

7.13.2 REPEAT ... UNTIL structure ................................................ 7 – 171

7.13.3 WHILE ... ENDW structure .................................................. 7 – 172

7.14 Linking Files................................................................................ 7 – 174

7.15 PLC Modules............................................................................... 7 – 177

7.15.1 Markers, Bytes, Words, and Double Words ........................ 7 – 177

7.15.2 Number Conversion ............................................................ 7 – 180

HEIDENHAIN TNC 430 PA - Page 851