December 2001 Data Transfer NC → PLC, PLC → NC 7 – 31
Tilting axes
290 1 – Current tilting axis geometry
description
2 Number of the
bit
Values of the individual bits of the
active MP7500 (kinematics table or
machine parameters).
M144 active
310 144 ––1 = M144 active
0 = M144 not active
TS touch-trigger probe
350 10 – Tool axis
11 – Effective radius
12 – Effective length
13 – Radius of calibration ring
14 1 Center offset (reference axis)
2 Center offset (minor axis)
15 – Direction of the center offset with
respect to spindle 0°
TT touch probe for tool measurement
350 20 1 Center of axis 1
2 Center of axis 2
3 Center of axis 3
21 – Effective radius
22 1 Probing position 1 in axis X
2 Probing position 1 in axis Y
3 Probing position 1 in axis Z
23 1 Probing position 2 in axis X
2 Probing position 2 in axis Y
3 Probing position 2 in axis Z
24 1 Probing position 3 in axis X
2 Probing position 3 in axis Y
3 Probing position 3 in axis Z
25 1 Probing position 4 in axis X
2 Probing position 4 in axis Y
3 Probing position 4 in axis Z
Group
name
Group
number
ID....
System data
number
NR....
System data
index
IDX....
System data item
To Next Page
Loading...
