Operating the Touchscreen | Gestures
3
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
135
Operating the simulation
The control offers touch operation with the following graphics:
Programming graphics in the Programming mode of operation
3-D view in the Test Run operating mode
3-D view in the Program Run Single Block operating mode
3-D view in the Program Run Full Sequence operating mode
Kinematics view
Rotate, zoom or move a graphic
The control supports the following gestures:
Symbol Gesture Function
Double tap Set the graphic to its original size
Drag Rotate the graphic (only 3-D graphics)
Two-finger drag Move graphics
Spread Magnify the graphic
Pinch Reduce the graphic
To Next Page
Loading...
