DR. JOHANNES HEIDENHAIN GmbH
D-8225 Traunreut .Tel. (08669) 31-O
SERVICE MANUAL TNC 151/155
Paae 45
Kundandienst
Se&ion 3.3
3.3 Software Exchange
General
The TNC 151/155 operating software is stored in 6 EPROMs
consisting of:
- Ic-Pl, IC-P2 (CLP Processor/Graphic Board)
- IC-P3...
IC-~6 (Main Processor Board)
Every operating software is specified with an 8 digit
Software NO.:
TNC
155
234 000 01 complete software Id. No.
234 020 01
234 000 primary software Id. No.
234 020
01 update software index
01
Each of the 6 programmed EPROMs (IC-Pl...IC-P6) is specified
with an 8 digit Id. No.:
TMC 155
234 000 4A complete Id. No. of the Prog. EPROM 234
020 4A
234 000 primary Id. No. of the Prog. EPROM 234
020
4 position on the board
4
A update index
A
The operating software includes:
o NC software (IC-PZ...IC-P5)
o PLC software (IC-P6)
TNC 151/155 B: Control with 0 NC software and
o PLC standard software
TNC 151/155 Q: Control with o NC software end
o PL.C standard software, or
PLC custom software
The dialog language of the TNC 151/155 is determined by
IC-P3 (located on Main Processor Board) and is discernible
from the different Id. Nos. of the programmed EPROMs.
Following dialog languages are available at this time
GW.Tl?.*
CD)
English (GB)
French
(F)
Italian (I)
Spanish (E)
Swedish (S)
Finnish (SF)
Dutch
(NL)
The Id.
NO.
of the other programmed EPROMs are the
same (for a given IC position) in all languages.
(prerequisite: same software issue!)
Exception: IC-P6 (PLC software)
The standard PLC program (EPROM position Ic-P6)
can be replaced with a custom PLC program for
the TNC 151/155 Q.
IC-P2
The export NC Software differs from the standard
NC Software in EPROM position IC-P2.
The dot matrix for all VDU displayed characters is contained
in IC-Pl (character generator).
To Next Page
Loading...
