www.heinner.com 7Kg, 220-240V~50Hz, 1200rpm
37
Unsatisfactory washing
result.
The contamination degree of
your laundries does not
match the programme you
have chosen.
Select the programme appropriate for
the contamination degree of your
laundries. (See programme table)
Amount of detergent used
insufficient.
Adjust the amount of detergent based
on the amount and contamination
degree of your laundries.
Laundries in excess of
maximum capacity put in
your machine.
Load your machine with laundries,
amount of which will not exceed
maximum laundry capacity.
Unsatisfactory
washing result.
Water being hard.
(Contaminated, lime water,
etc.)
Adjust the amount of detergent based
on the instruction of detergent
manufacturer.
Laundries distributed in your
machine non-
homogenously.
Spread your laundries in the
machine properly and
homogeneously.
As soon as the ma- chine
is loaded with water,
water dis- charges.
The end of water
discharging hose is too
low for the machine.
Set the water discharging hose on
appropriate height.
No water appears in
the drum during
washing.
No fault. Water is in the
unseen part of the drum.
Laundries have
detergent residues on
them.
Non-dissolving particles of
some detergents may
stick to your laundries as
white spots.
Perform an Extra rinse by setting your
machine to “Rinsing” programme, or
clean the spots using a brush after
your laundries dry.
Grey spots appear on
the laundries.
The reason for such spots
may be oil, cream or
ointment.
Apply the maximum amount of
detergent instructed by the detergent
manufacturer in the next washing
operation.
Spinning operation is not
performed or runs late.
No fault. Unbalanced load
control system has been
activated.
Unbalanced load control system will try
to spread your laundries homogenously.
Spinning operation will begin after your
laundry is spread. Place the laundry in
the machine in a balanced fashion the
next time.
To Next Page
Loading...
Need help?
General
