EasyManua.ls Logo

HELLER BFH6 - Cautions; Voltage Check and Modifications; Defrosting Procedures; Cord Replacement and Safety

HELLER BFH6
9 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
It must be checked that the voltage used is the same as the rated voltage before the refrigerator is
used.
Water contained in food or moisture in the air getting inside the refrigerator by opening doors may
form a layer of frost inside. It will weaken the refrigerator when the frost is thick. Therefore you
should defrost manually when the ice is thick. When defrosting, a pan is needed to put under the
evaporator to collect the defrost water.
Do not use any sharp tool to loosen or remove the ice as it may damage the evaporator or
refrigerator wall.
Do not use a hair dryer to speed up the defrost time.
If the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed
by the manufacturer, because special purpose tools are required.
It is dangerous to alter the specifications or attempt to modify this product in any way.
When the refrigerator is not in use for long periods, disconnect it from the electricity supply.
Wait for 5 minutes before restarting the unit after a power supply blackout.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not operate any product with a damaged cord or plug, or after the product malfunctions, or is
dropped or appears damaged in any way. Return the product to the place of purchase for
inspection, repair or replacement.