20
Atomizer
unit
Screws
Front guard
Pipes, Electrical cables
• Take the motor unit from the carton box and loose the bled fasteners.
Set the motor unit in a vertical position.
• Place the motor unit on the telescopic tube and tighten the fasteners firmly.
•
Loosen the preassembled screws on the motor front with screw driver.
•
Place the rear guard (identifiable by the small inner diameter)
and fasten the rear guard
onto the motor with the four screws.
Make sure the rear guard fits securely against the motor
•
housing.
• Loosen the securing screw on the fan blade. Slide the fan blade onto the motor shaft
with the shaft sleeve facing the motor.
• Align securing screw with flat groove in the motor shaft and tighten with screwdriver.
Ensure the fan blade is fixed on the motor shaft.
• Take the front guard and assembelled the atomizer unit on the front of the front guar by means the
fasteners.Pay attention that the atomizer unit is assembelled on the front guard straight and in right
position.
Step 5:
Assembly front with rear guard, Assembly the water pipes and misting system and
electrical part
• Open the grill clamps of the front guard and set the front guard with the fixed holder to rear guard
The atomizer unit must be in front.
• Fix front and rear guard together with the claps – see Figure:
To Next Page
Loading...
