Hello Kitty KT2051 - Alarm and Sleep Functions; Alarm Operation; Sleep Operation

6
ALARM OPERATION
SETTING THE WAKE UP TIME
1. Press and hold the ALARM BUTTON and repeatedly press the HOUR BUTTON to set the
correct wake up Hour.
2. Press and hold the ALARM BUTTON and repeatedly press the MINUTE BUTTON to set the
correct wake up Minute.
NOTE:
There is a PM INDICATOR located in the top left-hand corner of the clock display. Be sure to
observe the PM indicator when setting the alarm to make sure the alarm time is set correctly for
AM or PM. If the PM indicator is 'On', the alarm time will be "PM". If not, the alarm time will be
"AM".
CHECKING THE WAKE UP TIME
Whenever you want to check the wake up time, simply press the ALARM BUTTON. The display
will change from current time to wake up time. Release the ALARM BUTTON to return to current
time.
WAKE TO ALARM
1. Set the FUNCTION SELECTOR to the “ALARM” position. The AUTO INDICATOR will light
up to confirm that the alarm is set.
2. At the selected wake up time the alarm will beep and continue for about two hours and then
shut off automatically.
3. If you want to listen to the radio after the wake up time, set the FUNCTION SELECTOR to the
“AUTO” position. Adjust the tuning and volume for the radio program if required.
4. To stop the beep, press the ALARM Button once. The beep will stop but the alarm remains
set and will turn on the alarm on again at the same time the following day.
5. If you do not want the alarm to turn on the following day, set the FUNCTION SELECTOR to
the “OFF” position. The AUTO INDICATOR will go off.
WAKE TO RADIO
1. Slide the FUNCTION SELECTOR to “ON”, select the band, station and adjust the volume to a
level that you wish to hear when the wake up time is reached, then slide the FUNCTION
SELECTOR to the “AUTO” position. The AUTO INDICATOR will light on the display.
2. Reconfirm the wake up time setting by pressing the ALARM BUTTON.
3. At the selected wake up time the radio will turn 'On' and will play for about two hours and then
shut off automatically.
4. To stop the radio before it shuts off, press the ALARM BUTTON. The radio will stop but the
alarm remains set and will turn the radio on again at the same time on the following day.
5. If you do not want the radio to turn on the following day, set the FUNCTION SELECTOR to
the “OFF” position. The AUTO INDICATOR will go off.
SNOOZE ALARM
After the radio or beeping sounds, you may press the SNOOZE button for a few more minutes
sleep. The alarm will stop for approximately 9 minutes and then turn on again.
SLEEP OPERATION
SLEEP TO RADIO
You can program the sleep timer to play the radio for up to 1 hour 59 minutes and then shut off
automatically.
1. Slide the FUNCTION SELECTOR to “ON”, select the band, station, and volume level that you
want to listen then slide the FUNCTION SELECTOR to either the “OFF” or “AUTO” position.
2. Press the Sleep Button, the display will show 0:59 sleep time. At the same time radio will
come on and stay on for 59 minutes.
3. To shorten the ‘SLEEP’ time to less than “0:59”, press the Sleep Button together with the
Minute Button until the desired “SLEEP” time is shown on display.