Drill diameter o 3,5 mm
Min 750 mm Max 765 mm
Min.
240 mm
240
FIXING THE HEATER TO THE WALL.
Once the adjustable legs are turned in the
fixing height of the heater, wall rack is 750mm
from the floor. The adjustable legs have a 15mm
adjustment allowance just in case the floor is on
an incline.
Check after fixing to the wall that both adjustable
legs are evenly set against the floor.
The measurement between the fixing holes of the
240 mm
rack to be fixed on the wall is 240mm.
A
B
Wall fixing parts:
- locking pieces for the heater (A) 2 pieces
- wall fastener (B) 1 piece
- metal screw 4.2 x 13mm 2 pieces
- cover screw 6 x 40mm 2 pieces
Fit the locking pieces (A) for the heater into the
holes in the back plate so that the entering part
turns upwards.
Fix the wall rack (B) to face the wall so that the
holes where the locking pieces are fixed will be
upwards. The rack can also be fixed directly to
the heater. Mark in advance the locations of the
screws to the wall and, if needed, drill small
guide holes and then fix the heater to the wall
with the screws supplied.
The illustration shows how the wall rack should
be fixed in the heater.
The parts in the heater are fixed to the wall rack
with metal screws.
2
To Next Page
Loading...
