After installing the inside stones, install the support
rods above them.
The illustration shows the order.
The heater body has both vertical and end limiters
which prevent the movement of the soapstone both
vertically and horizontally once they are installed.
Install the support rods between the vertical limiters.
The soapstones also remain between the vertical
limiters.
End limiter
The illustration shows the installed support rods.
The soapstones are installed as follows:
- Install the upper stone first.
- Place as shown in the illustration: first one of the
ends under the edge; push the stone then under the
other edge until it stops in the end limiter.
NOTE!
The stone has to remain behind the vertical limiter.
8
To Next Page
Loading...
