30
Install and program the control
panel
The control panel has several holes in the back. These holes are used to mount the
control panel outside the sauna. Read the measurements and use the screws to mount
the control panel.
Mount the control panel on the wall
1. Mark on the wall where the control panel should be mounted.
2. Unscrew the lid to the control panel.
3. Lead the cable through the control panel so that it’s placed before the lid is put back
on (see page 31).
4. Set the metal screw 4 x 25 mm in the wall and hang the control panel on the middle
screw.
5. Mount the control panel in the wall with the screws 4 x 25 mm. The screws should be
placed in the two holes at the bottom of the control panel.
6. Put the lid back.
Information for the installer
Control panel
measurement
Widht: 250 mm
Hight: 222 mm
Depth: 80 mm
To Next Page
Loading...
