Helo Hanko STJ - Location for the Connection Box; Moving the Heater Controls from One Side to the Other; Image 3 Locating the Connection Box for Connection Cable in the Sauna Room

image 3 Locating the connection box for connection cable in the sauna room
2.10 Location for the connection box
A = Specified minimum safety clearance
1. Recommended location for the connection box
2. Silumin box recommended in this area.
3. This area should be avoided. Always use a silumin box.
In other areas, use a heat-resisting box (T 125 °C) and heat-resisting cables (T 170 °C). The connection box must be clear
of obstacles. When installing the connection box to zones 2 or 3, refer to the instructions and regulations of the local ener-
gy supplier.
2.11 Moving the heater controls from one side to the other
By default, the thermostat and the timer switch are located
on the left hand side of the heater when viewed from the
front. They can be moved to the other side, if necessary.
The work may only be carried out by a qualified electrician.
1. Turn the heater upside down. Unfasten the bottom plate.
2. Pull off the dials for the thermostat and the timer switch.
Unfasten the two screws in the thermostat and timer
switch frame. Remove the plastic covers for the electric
box and the outer shell from the back. Move the thermostat,
the timer switch and their frame to the other side and
refasten using two screws. Insert the plastic covers in the
now empty holes.
Push the thermostat and timer switch dials back into place.
NOTE! Leave a minimum of 1 mm between the dial and the
heater outer shell.
3. Fasten the bottom plate, install the heater and check that it works.
Product Manual Hanko STJ
10
200 mm
A A
3.
2.
1.
500 mm
500 mm
Heater
4
3
5
2
1
1
2
5
3
4
1. Thermostat
2. Timer switch
3. Dial
4. Temperature limiter reset
5. Outer shell of the heater