Specifications
Operating voltage 230V – 240V 1N~ / 2~, (3.4 kW – 7.7 kW)
230V 3~, (3.4 kW – 14 kW)
400V – 415V 3N~ (3.4 kW – 14 kW)
Output options 3.4 / 4.7 / 6.0 / 7.7 / 9.5 / 12.0 / 14.0 kW
Generator dimensions 520 x 380 x 160 mm
Parallel coupling See the connecting instructions for parallel coupling of
several generaors
Enclosure class IP 20
Installation Floor/wall
Water tank material Aisi 304, stainless steel
Water tank pipes Aisi 314, stainless acid-proof steel
Weight when empty about 11 kg
Automatic flushing one hour after switching off (optional, Automatic drain valve)
Interim rinsing during use (optional, Automatic drain valve)
Electric water level adjustment
Electric overfill protector
Calcium repelling, self cleaning electrodes
Overheating protector
Safety valve
Digital control panel, Helo T1
Easy maintenance
Replaceable heating elements (3 pcs)
The steam generator has an overheating protector equipped with a reset button.
Fill cap for deliming agent (citric acid) is located on the lid of the steamer.
Components easily replaceable, circuit board, heating elements, surface sensor.
Accessories
- Scent pump, (Essence pump kit 0038130)
- Scent pump canister 20 l (0038132)
- Automatic flush and rinse cycle. (Automatic drain valve 4310130)
- Steam nozzles (3.4 – 6.0 kW 1 piece, 7.7 – 9.5 kW 2 pcs, 12 – 14 kW 3 pcs) (7819604)
General
HNS-Touch steam generators are only intended for use in heating spa facilities. Using steam generators in other
areas than steam rooms can damage the building's structure.
The manufacturer is not responsible for damages caused if the unit has been used incorrectly or in a manner for
which the unit was not designed for.
Water and steam pipe connections must be made prior to connecting the unit into the mains.
Due care and attention must be taken when making the connections. Proper sealing must be ensured for all
extensions. A good extension must have at least taped over threaded connections, but it is recommended that
connections are soldered.
Testing the water before using the steam generator.
The test packet that comes with the steamer includes test slips, which can be used for testing the water hardness
number as follows:
Dip the test slip in water for about 1 second, take it out and shake off the excess water. After a minute, compare the
colour code appearing on the test slip with the code key in the packet.
User and installation manual HNS-T1
3
To Next Page
Loading...