Steame generator
Safety valve installation
The safety valve is installed on the steam pipe with using the provided ½” T connector.
A separate downpipe directly to a drain or to the floor is installed on the safety valve. NOTE: Safety valve's downpipe
must not be connected to the steam generator's draining pipe or the steam pipe.. Use the provided sealing tape or
similar sealing on the threads.
Image. Installation of the safety valve and the automatic drain valve
User and installation manual HNS-T1
7
Water connection, ¾”
Plug for the electromagnetic
flushing valve
Water draining, 1/2"
Manual or electric valve
Main switch
Filling tube for the
deliming agent
Steam pipe ½”
Strain relief clamp for
the control panel cable
Strain relief clamp for the
Heater connection cable
To Next Page
Loading...
