EasyManua.ls Logo

Hendi 240410 - Page 5

Hendi 240410
86 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
EN
Intended use
The appliance is intended for buffet and house-
hold use.
The appliance is designed only for rice cooking
and keeping the temperature of the cooked rice.
Any other use may lead to damage of the appli-
ance or personal injury.
Operating the appliance for any other purpose
shall be deemed a misuse of the device. The user
shall be solely liable for improper use of the de-
vice.
Preparations before using for the first time
Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier
immediately and do NOT use the appliance.
Take out all the accessories such as measuring
cup, rice scoop and silicone non stick pan pad.
Remove all the packing material and protection
film (if applicable).
Clean the parts of the appliance thoroughly be-
fore using for the first time (See “Cleaning and
maintenance” session).
Place the appliance on a level and steady surface,
unless mentioned otherwise.
Make sure there is enough clearance around the
appliance for ventilation purposes.
Position the appliance in such a way that the plug
is accessible at all times.
How to keep cooked rice warm and tasty?
Keeping cooked rice warm or using the ‘Keep
Warm’ function for more than 5 hours may cause
discolouration or generate an objectionable
odour. The sooner rice is served, the better it will
taste.
There is a minimum quantity of rice to keep
warm. When using the keep warm cycle, be sure
you have at least 4 bowls full or 6 bowls full of
cooked rice in the pan.
To prevent a dry, discoloured effect and objection-
able odour of the cooked rice, keep the outer lid
perfectly closed after serving rice.
Do not leave the rice scoop or other utensils in
the pan during the keep warm cycle.
Do not use the keep warm feature to reheat left-
over cold rice.
Moisture collector
Detaching of the interception tank:
Grab both sides of the interception tank and pull.
Attaching of the interception tank:
Insert the upper edge into the cannelure of the
interception tank and press it on.
After every use the water drop-interception tank
should be detached and emptied!

Other manuals for Hendi 240410