EasyManua.ls Logo

Hendi MASTERCOOK DIGITAL 207345 - Page 5

Hendi MASTERCOOK DIGITAL 207345
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
EN
Caution! Securely route the power cord if necessary in order to prevent unintentional
pulling or contact with the heating surface.
Do not wash the appliance with water. Washing can cause leakages and increase the risk
of electric shock.
Do not clean or store the appliance unless it is completely cooled down.
No part is dishwasher safe.
Always remove the plug from the socket whenlling or cleaning the deep fryer.
The electrical installation must satisfy the applicable national and local regulations.
The Fryer tank and element should be placed in a safe position in your kitchen before
usage due to the hot contents when in use.
To avoid the risk of fire, do not allow the oil level to drop below the L- mark (MIN level).
Always use plenty of oil in the oil container.
Grounding installation
This appliance is classified as protection class I
appliance and must be connected to a protective
ground. Grounding reduces the risk of electric
shock by providing an escape wire for the electric
current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly
installed and grounded.
Preparations before using for the first time
Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier im-
mediately and do NOT use the appliance.
Remove all the packing material and protection
film (if applicable).
Clean the appliance with luke-warm water and
a soft cloth.
Place the appliance on a level and steady surface,
unless mentioned otherwise.
Make sure there is enough clearance around the
appliance for ventilation purposes.
Position the appliance in such a way that the plug
is accessible at all times.
Installation
Place the appliance on a level, stable, clean,
heat-resistant and dry surface with its rubber
feet.
Carefully install the back support with heating el-
ement on the rear edge of the oil container.
Note:
1. Make sure that the pin on the back support is in
the correct position & properly mounted.
2. The appliance should be placed in a safe posi-
tion in your kitchen before use due to hot hazard
when in use.

Related product manuals