6
Faults
Fault Possible cause Fault Possible cause
burner fails to ignite
at all:
defective ignition
burner does not ignite
completely:
gas cylinder (almost) empty
defective thermocouple kink in gas hose
dirty spark plug
gas cylinder valve not entirely open
defective pressure regulator
empty gas cylinder clogged jet
kink in gas hose
defective valve
clogged jet
If in doubt, please contact your supplier.
Note
• It is to be recommended to replace the gas hose
after 3 or 4 years (see date shown on hose). The
gas hose becomes porous after a time.
• Consult the local regulations, these may differ.
• Always store gas bottles upright, even when
empty.
• The Powergrill is supplied for use with propane
gas. It is not allowed to modify this appliance, if
this is desired please contact the manufacturer.
Assembling the undercarriage
The following parts have been supplied for the as-
sembling of the under-carriage:
- 1 wheel frame
- 1 body frame
- 2 bolts M6x40.
- 2 bolts M6x65.
- 4 Cap nuts M6.
- 2 rings M6.
- 1 star bolt M6
Assembly
• Remove all protective plastic foil
•
Fasten the frame with the already assembled
wheels to the under part of the Power grill. Use
the parts delivered; M6x40 bolts and the M6 cap
nuts. Take note of the frame stand, the bend in this
frame has to be slightly bent upwards at the ends.
• Assemble the body frame the wheel frame. Take
note, the supplied rings has to be positioned in
the inner side of the frame and also where the
two frames join together. Use the long M6 x 65
bolts and the M6 cap nuts.
• Fasten the U-shaped part to the under part of the
body frame. Use the star bolt supplied. Check if
it’s really tightened.
To Next Page
