hengel Bi-Tronic Control User Manual

Hengel Industrie
ZA, Les Berges du Rhins - 42120 PARIGNY - FRANCE
Tél : +33 (0)4 77 23 40 00 - Fax : +33 (0)4 77 23 40 09
Email: infos@hengel.com
Website: www.hengel.com
Notice-EN-BITRONIC-ST-F-1
User instructions
Bi-Tronic Control - Retarder proving
To be conserved by the user

hengel Bi-Tronic Control Specifications

General

Brand	hengel
Model	Bi-Tronic Control
Category	Control Unit
Language	English

Summary

General Introduction

Interface Areas Overview

Description of the different zones and controls on the Bi-Tronic Control interface.

Key Buttons and Indicator Lights

Explanation of button functions and indicator light meanings for the Bi-Tronic Control.

Getting Started with the Bi-Tronic Control Interface

Initial Device Startup

Steps to turn on the Bi-Tronic Control interface and initial display indications.

Clock Setting Procedure

Guide to adjusting the hours and minutes on the Bi-Tronic Control display.

Example of Use

Operating Modes Overview

Introduction to the two modes of operation: Direct mode and Retarder proving cycle mode.

Direct Mode Operation Details

Diagram and explanation of the Direct mode process for proving.

Retarder Proving Cycle Details

Diagram and explanation of the Retarder proving cycle mode.

Detailed Direct Mode Operation

Detailed steps for using the Direct mode, including setting temperature and humidity.

Adjusting Temperature in Direct Mode

Procedure to change the temperature set point in Direct mode.

Adjusting Humidity Rate in Direct Mode

Procedure to change the humidity rate set point in Direct mode.

Cycle Mode Operation

Description of how to launch and operate the retarder proving cycle for 24, 48 or 72h.

Setting Cycle Parameters

Guide to adjusting blocking temperature, proving temperature, humidity, and time.

Cycle Monitoring and Completion

Explanation of cycle monitoring via LEDs and end-of-cycle indications.

Faults and Parameters

Stopping the Control Interface