Hengstler eXtendo X-80 - Sensors and LED Indicators Operation; Paper Entrance; Black Mark Sensor Function

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 14 of 95
2.1.6 ESC % +[n] Character set selection
[Name] Character set selection
[Function] This command selects the primary or secondary character set.
[Code] [1B]
16
+ [25]
16
+ [n]
[27]
10
+ [37]
10
+ [n]
[Description]
1. The “ESC %+[n]” command selects the primary or secondary character set. Either character set
can be changed by uploading a new character set to the printer using the supplied font upload
tool.
2. If parameter [n] is [0]
10
, then the primary character set is selected.
3. If parameter [n] is [1]
10
, then the secondary character set is selected..
4. The type of primary/secondary character set (e.g. 8x16, 12x24, 16x32, 20x40) required is
selected with the print mode command (see “ESC ! + ...”).
Printing mode specification
(command “ESC ! + ..”, lower 4 bits)
Primary
character set
Secondary
character set
08 x 16 08 x 16 08 x 16
12 x 24 12 x 24 12 x 24
16 x 32 16 x 32 16 x 32
20 x 40 20 x 40 20 x 40