Hengstler eXtendo X-80 - GS L+[N]+[M] Left Margin Specification

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 20 of 95
2.1.12 GS L+[n]+[m] Left margin specification
[Name] Left margin specification
[Function] This command sets the left margin.
[Code] [1D]
16
+ [4C]
16
+ [n] + [m]
[29]
10
+ [76]
10
+ [n] + [m]
[Description]
1. The “GS L+[n]+[m]” command specifies the left margin in dots.
2. Both parameters [n] and [m] specify the left margin, whereas this margin is calculated as follows:
“left margin” = [n] + [m] * [256]
10
.
3. The range of parameter [n] is [0]
10
≤ [n] ≤ [255]
10
.
4. The range of parameter [m] is as follows.
X-56 (203 dpi): [0]
10
≤ [m] ≤ [1]
10
X-80 (203 dpi): [0]
10
≤ [m] ≤ [2]
10
5. If the result of the calculation [n] + [m] * [256]
10
is greater than the number of dots in the dot row
(448 for the X-56/203 dpi and 640 for the X-80/203 dpi), then this command will be ignored.