eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 26 of 95
2.1.18 ESC ‘%‘+[n] Character Set and Country
Code Selection
[Name] Character Set and Country Code Selection
[Function] This command selects the character set and the country code.
[Code] [1B]
16
+ [25]
16
+ [n]
[27]
10
+ [37]
10
+ [n]
[Description]
1. Command “ESC ‘%’ [n]” selects the primary or secondary character set and the country code
within this character set.
2. Either character set can be changed by uploading a new character set to the printer using the
supplied font upload tool.
3. Parameter [n] specifies character set and country code. The following figure shows the
relationship between the bits of parameter [n] and character set and country code:
Parameter [n], bit Value Printing mode
(LSB)
b0 – b2 0 Primary character set (default)
1 Secondary character set
2 – 7 Reserved for future use
b3 – b7
(MSB)
0 Country code disabled (default)
1 USA
2 France
3 Germany
4 U.K.
5 Denmark 1
6 Sweden
7 Italy
8 Spain 1
9 Japan 1
10 Norway
11 Denmark 2
12 Spain 2
13 Latin America
14 Japan 2
15 - 31 Reserved for future use
4. The country code characters are available from firmware version R2-V1.01f and later.
To Next Page
Loading...
