Hengstler eXtendo X-80 - ESC D+[N] Forward N-Line Feed

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 35 of 95
2.1.24 ESC d+[n] Forward n-line feed
[Name] Forward n-line feed
[Function] This command prints the data and feeds a line, then feeds the paper by [n]
character lines.
[Code] [1B]
16
+ [64]
16
+ [n]
[27]
10
+ [100]
10
+ [n]
[Description]
1. The “ESC d+[n]” command feeds paper by a character line count specified with parameter [n].
2. Condition [0]
10
≤ [n] ≤ [255]
10
must be satisfied.
3. After [n] lines are fed, the next print position is located at the left edge on the line.
4. When there is data in the print buffer, the data contained in the buffer is printed upon receipt of
this command, after which paper is fed by [n] character lines.
5. Pitch or spacing is also taken into account by this command.