Hengstler eXtendo X-80 - EN55022 Emissions Standards Compliance; EN55024 Electromagnetic Susceptibility

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 38 of 95
2.1.27 ESC [F2] [06] [02] [n1] [n2] Position Stamp Retract
[Name] Position Stamp Retract
[Function] This command feeds paper backwards to an offset relative to the last Position
Stamp Set position.
[Code]
[1B]
16
+ [F2]
16
+ [06]
16
+ [02]
16
+ [n1] + [n2]
[27]
10
+ [242]
10
+ [6]
10
+ [2]
10
+ [n1] + [n2]
[Description]
1. The command “ESC [F2] [06] [02] [n1] [n2]” feeds paper backwards to an offset relative to the last
Position Stamp Set position.
2. Parameters [n1] and [n2] specify a target position in millimeters from the last Position Stamp Set
location. Together they form a 16-bit, unsigned integer with a valid range up to 65,535.
Parameter [n1] is the MSB and parameter [n2] is the LSB of this number.
3. The conditions [0]
10
≤ [n1] ≤ [255]
10
and [0]
10
≤ [n2] ≤ [255]
10
must be satisfied.
4. Buffered print data will be printed before the printer processes this command.
5. By using the “Position Stamp Set” command at the start of a printout and the “Position Stamp
Retract” command at the end of the printout, an application is able to retract the paper to the start
of the printout and invalidate it afterwards by overprinting it (E.G., by printing “VOID” on the
printout).