Hengstler eXtendo X-80 - ESC [F2] [09] [01] [N] Paper Eject

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 39 of 95
2.1.28 ESC [F2] [09] [01] [n] Paper Eject
[Name] Paper Eject
[Function] This command ejects the paper from the printer, either forward or rearward.
[Code]
[1B]
16
+ [F2]
16
+ [09]
16
+ [01]
16
+ [n]
[27]
10
+ [242]
10
+ [9]
10
+ [1]
10
+ [n]
[Description]
1. The command “ESC [F2] [09] [01] [n]” causes paper to advance or reverse until the paper is
ejected from the printer. This command is most commonly used when printing precut tickets to
eject the finished ticket.
2. Parameter [n] determines if the paper will be ejected from the front or the rear of the printer. A
value of [1]
10
will cause the paper to be ejected from the front, while any other value in the range
[0]
10
≤ [n] ≤ [255]
10
will cause the paper to be ejected from the rear.
3. Attempting to eject the paper forward with roll paper will, after approximately 1.5 meters, cause
the paper to reverse until it reaches the printer and will then cause the printer to enter an error
condition.