Hengstler eXtendo X-80 - ESC [F0]+[0 C]+[00] End Block Rotation

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 44 of 95
2.1.33 ESC [F0]+[0C]+[00] End block rotation
[Name] End block rotation
[Function] This command closes the Start Block Rotation command and immediately causes
printing of the data sent after the Start Block Rotation command was received.
[Code] [1B]
16
+ [F0]
16
+ [0C]
16
+ [00]
16
[27]
10
+ [240]
10
+ [12]
10
+ [00]
10
[Description]
1. The “ESC [F0]+[0C]+[00]” command ends the transmission of data to be printed as a block that
was initiated by the Start Block Rotation command and causes it to be printed.