Hengstler eXtendo X-80 - GS +[M]+[N] Print Stored Image Data

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 47 of 95
2.1.36 GS '+[m]+[n] Print stored image data
[Name] Print stored image data
[Function] This command causes stored image data to be printed.
[Code] [1D]
16
+ [27]
16
+ [m] + [n]
[29]
10
+ [39]
10
+ [m] + [n]
[Description]
1. The “GS ‘+[m]+[n]” command causes image data, stored in flash memory, to be printed.
2. Parameter [m] specifies the identification number of the stored image. (The first stored image is
identification no. 0, the second ID no. 1, etc.)
3. The range of parameter [m], the identification number, is [0]
10
≤ [m] ≤ [255]
10
.
4. If there is no registered image stored for a transmitted identification number, then the command is
ignored.
5. Parameter [n] specifies the print mode, as follows:
Parameter [n]
Print mode
Caption
[00]
10
Normal The stored image data is printed in the original stored size.
[01]
10
Double width The stored image data is printed in double width.
[02]
10
Double height The stored image data is printed in double height.
[03]
10
Double width and
height
The stored image data is printed in double width and
height.
6. Use of values for Parameters [m] and [n] other than as described above will cause the command
to be ignored.
7. Images can be created and stored in the eXtendo
®
printer by using the tools that come with the
eXtendo
®
print driver.