Hengstler eXtendo X-80 - GS E+[N]+[M] Bar Code Bar Width Setting

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 48 of 95
2.1.37 GS e+[n]+[m] Bar code bar width setting
[Name] Bar code bar width setting
[Function] This command sets the width of the bar code narrow and wide bars.
[Code] [1D]
16
+ [65]
16
+ [n] + [m]
[29]
10
+ [101]
10
+ [n] + [m]
[Description]
1. Command “GS e+[n]+[m]” defines the width of the bar code bars.
2. The bars in a one-dimensional bar code can be wide or narrow and black or white.
NARROW BLACK BAR
NARROW WHITE BAR
WIDE BLACK BAR
WIDE WHITE BAR
parameter „n“
parameter „n“
parameter „m
n“
parameter „m
n“
3. Parameter [n] specifies the width of a narrow white/black bar in dots.
4. Parameter [m] specifies the width of a wide white/black bar in dots.
5. When the bar code selected does not consist of wide bars and/or narrow bars, the value of
parameter [n] is set as the minimum width.
6. The initial value of parameter [n] is [2]
10
.
7. The initial value of Parameter [m] is [6]
10
.
8. The following conditions must be satisfied:
[1]
10
≤ [n] ≤ [255]
10
and [1]
10
≤ [m] ≤ [255]
10