Hengstler eXtendo X-80 - GS H+[N] Bar Code Height Setting

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 49 of 95
2.1.38 GS h+[n] Bar code height setting
[Name] Bar code height setting
[Function] This command sets the height of a bar code in dots.
[Code] [1D]
16
+ [68]
16
+ [n]
[29]
10
+ [104]
10
+ [n]
[Description]
1. Command “GS h+[n]” defines the height of a bar code.
2. Parameter [n] specifies the height of the bar code in dots.
3. The following conditions must be satisfied:
[1]
10
≤ [n] ≤ [255]
10
.
4. The default value of parameter [n] is [60]
10
.