Hengstler eXtendo X-80 - GS W+[N] Bar Code Width Magnification Setting

eXtendo
®
Em ulation Command Set Reference
Part No. D 684 112 Mod.Nr. 4 150813 LEV Page 50 of 95
2.1.39 GS w+[n] Bar code width magnification
setting
[Name] Bar code width magnification setting
[Function] This command sets the width magnification for a bar code.
[Code] [1D]
16
+ [77]
16
+ [n]
[29]
10
+ [109]
10
+ [n]
[Description]
1. Command “GS w+[n]” specifies the width magnification of a one-dimensional bar code by
multiplying the dot width of the narrow and wide bars by a specified integer value.
2. Parameter [n] specifies the horizontal magnification of a bar code.
3. The following conditions must be satisfied:
[1]
10
≤ [n] ≤ [4]
10
.
4. The default value of parameter [n] is [1]
10
.
5. The widths of the narrow and wide bars (black and white) are multiplied by [n].
6. This command is ignored two-dimensional bar codes.